![]() ![]() Error code 2000-0511 - Msg: Fan - The failed to respond properly.Before doing so I did the ePSA Dell Diagnostics and it notified me of two error codes: Yesterday I needed to use a software that isn't available on Linux so I booted into Windows and decided to try looking at the BIOS and updating them. After that the fans seemed to improve only slightly but still revved and stayed on pretty high and loud. Everything seemed fine there wasn't a ton of dust. I took apart the PSU, fully cleaned it to the best of my ability using a forced air canister, and did the same for the motherboard, case, etc. I purchased an Asus wifi adapter, so when I installed it I cleaned out the case as well. It would rev up and down constantly as I used the websites. If I went onto a website like Reddit, Youtube, Amazon, etc the temp would only climb to the low to mid 40Cs, but the fan speed would get all the way to 3-5k RPM. ![]() The CPU temp would sit in the low to mid 30Cs under normal circumstances with PSU/case fan speed around 1200 RPM. The only issues that the PC has had have been concerning the fans. I purchased a refurbished Dell Inspiron 620 running Windows 10 in January and installed Manjaro Linux alongside of it as my main OS. Ongoing fan issues but after updating BIOS I received fan/chassis id errors and now motherboard fan is reading at 0 RPM ? But since Fancontrol worked when I last tried it on Ubuntu 20.04 I don’t know if this can be a hardware issue.Īny help would be greatly appreciated, and if more information is needed, I can try to reinstall it and provide it.Linux/Windows 10 Dual Boot. ![]() The chassis fans in question are set in BIOS as DC fans, but I’ve had a few issues over on the Windows side with ASUS AI Suite not properly recognizing them. I’ve entertained the thought that it might be because of my hardware setup - I have four DC fans installed in my case, and all of them are connected to an ARGB LED and Fan Splitter that my case came with, and then that fan splitter is connected to the motherboard with a PWM cable. I have no idea what the issue could be however. I had the actual terminal output saved to a document, but it was late, I was growing increasingly frustrated and I booted back into Windows and deleted the Manjaro partition, so if needed I can go through the entire process again and provide an exact terminal output, because I really, really want to properly start running Manjaro and it would be a shame for me to give up like this. ![]() I looked around the internet for a solution and I couldn’t find one, but I ran “systemctl status fancontrol”, and it told me the service hadn’t started with an error along the lines of “Couldn’t start PWM for hwmon3/pwm1”. However, all my fans continued to spin at 100%. I ran sudo sensors-detect, it found them, I ran sudo pwmconfig, everything worked perfectly, it found all fans, I saved the configuration file, then I installed Fancontrol GUI, set the fancurves, and started the service. My system is built with an ASUS PRIME B450 PLUS, and I know that the sensor inside it isn’t normally supported, so just like I did on Ubuntu, though through AUR this time, I installed the IT87 sensor, did modprobe, it found it, and then I followed the instructions from the Arch wiki. I have previously, around a year ago, been able to get it to work on Ubuntu. I have been trying to install Manjaro in a dual boot scenario, and I was trying to set up fancontrol and fancontrol GUI. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |